The SAE 1095 TR strip sold by Sandsteel has a reference hardness of 50 to 54 HRC. This condition can meet parts that require greater hardness, as long as the geometry and manufacturing operations are compatible with the material.
QUENCHED AND TEMPERED CARBON STEEL
SAE 1095 TR spring steel strip
SAE 1095 TR is an imported high-carbon spring steel strip supplied quenched and tempered. It is used to make flat parts that require limited forming. The supplied condition eliminates a later hardening step and reduces the number of production steps.
Key feature: high fatigue resistance, good toughness and suitable surface roughness, allowing bends of up to 90°.
Common applications
• Scraper blades and saws for foam, mattresses, wood and paper
• Springs, rings and washers
• Compressor valves, spatulas and construction accessories
• Guides, rulers, bands and steel strips
• Cutlery
• Cutting tools
Available in coils, rolls or strips slit to the required width within our slitter’s capacity. Maximum width: 310 mm.
C | Si | Mn | P max. | S max. | Cr (max.) |
|---|---|---|---|---|---|
0.95–1.05 | 0.30 max. | 0.60 max. | 0.03 max. | 0.03 max. | 0.30 max. |
Composition may vary with the standard and manufacturer. | |||||
Condition | Hardness | Tensile strength | Finish | Edges |
|---|---|---|---|---|
Hardened | 50–54 HRC | 1,600–2,100 MPa | Polished white | Sharp edges |
Confirm the finish and edge condition when requesting a quote. | ||||
Thicknesses and | 0.10 ±0,010 | 0.20 ±0,015 | 0.40 ±0,020 | 0.80 ±0,025 |
|---|---|---|---|---|
Width | Maximum 310 mm | |||
Typical stock tolerances. Values may vary with origin, manufacturer and delivery condition. Other thicknesses are available on request. | ||||
CS95 | G1095 | SK-4 | DIN 1.1274 | C100S | UHB 20c | SHT 20 |
Product FAQs
Sandsteel references are 50 to 54 HRC for SAE 1095 TR and 44 to 48 HRC for SAE 1070 TR. The difference matters for wear, cutting and forming; Greater hardness does not mean better results for the entire piece. Hardness of 1095 TR and requirement on the tool.
The hardness of SAE 1095 TR increases the demands on the tool. Sharpness, looseness and thickness interfere with the formation of burrs and microcracks, which can compromise an edge subject to stress. Edges and tolerances when cutting 1095 TR.
No. Polished White describes the surface finish of SAE 1095 TR, not corrosion resistance. The material remains a high carbon steel, subject to oxidation when exposed without adequate protection. Polished white finish and oxidation of the 1095 TR.