Sandsteel sells AISI 301 spring-cold-worked stainless steel strip, with a reference hardness of 38 to 42 HRC. To manufacture clips, check the expected deformation and dimensions of the drawing, as well as the environment in which the piece will work.
COLD-WORKED AUSTENITIC STAINLESS STEEL
AISI 301 stainless spring steel strip
Cold-worked AISI 301 stainless spring steel strip is a cold-rolled austenitic stainless steel that gains high mechanical strength through cold deformation. It combines spring action, good corrosion resistance, formability and a bright surface finish. It is suitable for components subject to bending, springback and repeated loading, and is widely used to make springs, latches, clips and precision stampings.
Key feature: high mechanical strength and spring action, good corrosion resistance and a strong work-hardening response.
Common applications
• Flat springs, spring leaves and elastic components
• Clamps, retainers, clips, latches and rings
• Stamped parts subject to springback
• Washers, bands and fasteners
• Components for precision equipment and mechanisms
• Parts for the automotive, electrical and electronics industries
• Cladding and components with a bright finish
• Technical parts exposed to moisture and moderately corrosive environments
Available in coils, rolls or strips slit to the required width within our slitter’s capacity. Maximum width: 310 mm. Thicknesses above 2.00 mm are available only as blanks or pieces.
Grade | C max. | Si max. | Mn max. | P max. | S max. | Ni | Cr |
|---|---|---|---|---|---|---|---|
301 | 0.15 | 0.75 | 2.00 | 0,045 | 0.03 | 6.0–8.0 | 16.0–18.0 |
Composition may vary with the manufacturer and delivery specification. | |||||||
Condition | Hardness | Tensile strength | Finish | Edges |
|---|---|---|---|---|
Cold-worked | 38–42 HRC | 1220–1350 MPa | Bright | Sharp edges |
Confirm the BA finish and edge condition when requesting a quote. | ||||
Thicknesses and | 0.05 ±0.01 | 0.25 ±0.03 | 0.60 ±0.05 | 1.00 ±0.06 |
|---|---|---|---|---|
Width | Maximum 310 mm | |||
Typical stock tolerances. Values may vary with origin, manufacturer and delivery condition. Thicknesses above 1.20 mm are available only as blanks or pieces. | ||||
DIN 1.4310 | X10CrNi18-8 | UNS S30100 |
Product FAQs
The hardening of work-hardened AISI 301 comes from cold deformation. The strip sold by Sandsteel has a reference of 38 to 42 HRC; its mechanical condition differs from that of annealed stainless steel. AISI 301 strip hardening.
Elastic return is part of the behavior of cold-worked AISI 301. The angle obtained after removing the load depends on the geometry, thickness and mechanical condition; There is no single tool setting that is valid for all parts. Elastic return in bending of AISI 301.
There is no such guarantee. Heating can reduce the hardening acquired by work hardening and change the elastic behavior. Welding and other heat operations require evaluation of the affected region when the part needs to maintain its spring function. Heating and properties of AISI 301.