Sandsteel sells conventional scraper blades. Send the current blade specification, with profile and measurements, and identify the equipment and application. This data allows you to check the replacement without depending solely on the appearance of the used part.
SCRAPER BLADES FOR PRINTING
Conventional scraper blades
Conventional scraper blades (doctor blades), also known as radial blades, are used in flexographic and rotogravure printing when a self-sharpening profile is unnecessary. Made from fine-grained high-carbon or stainless steel, they provide consistent scraping and ink metering, especially when printing lines and solid areas.
Key feature: edge treatment removes burrs, reducing the risk of scratches on the anilox cylinder and promoting even scraping.
Common applications
• Flexographic packaging printing
• Scraping and metering ink on the anilox cylinder
• Rotogravure
• Varnish application in rotary processes
• Printing of lines and solid areas
• Doctor blade systems using radial or conventional blades
Available in rolls or coils packed in 50- or 100-meter boxes, or as strips or pieces cut to the required length. Special sizes are available on request.
Steel | C | Si | Mn | Cr | Mo | P max. | S max. |
|---|---|---|---|---|---|---|---|
High carbon | 1.00 | 0.25 | 0.45 | 1.40 | — | 0,015 | 0,004 |
Stainless | 0.68 | 0.40 | 0.70 | 13.00 | 1.00 | 0,025 | 0,015 |
Composition may vary between batches of raw material. | |||||||
Condition | Hardness | Tensile strength |
|---|---|---|
High carbon | 54-56 HRC | 2,050 ± 100 MPa |
Stainless | 52-56 HRC | 1,900 ± 100 MPa |
Conventional blades receive edge treatment to remove burrs. | ||
Thickness | Standard stock widths | Materials |
|---|---|---|
0.15 mm | 10 / 20 / 25 / 30 / 35 / 40 / 45 / 50 / 55 / 60 / 70 mm | High-carbon and stainless steels |
0.20 mm | 10 / 20 / 25 / 30 / 35 / 45 / 50 / 55 / 60 / 70 mm | High-carbon and stainless steels |
0.30 mm | 40 mm | High-carbon and stainless steels |
Dimensions are given as thickness × width. Standard packaging is 50- or 100-meter boxes. Sandsteel also supplies pieces cut to the required length. | ||
Product FAQs
No. Thickness, length, profile and material also affect fit and contact. The same width alone does not prove compatibility between a conventional blade and the equipment's scraping set. Conventional blade measurements and fit.
Not necessarily. Pressure, alignment, contamination and surface condition also influence scraping. When these factors are involved, a new blade can repeat the defect even without showing initial wear. Scraping failures and equipment condition.
The distinction involves the construction and behavior of the profile during wear. The comparison between conventional and self-sharpening blades depends on the equipment and material processed, not just the commercial name of the version. Comparison between conventional and self-sharpening blade.